Improve mask fit
2. Balance mask
- When applying the mask, take care to apply the correct tension to the headgear straps to achieve a balanced position on the face. The most common mistake is over tightening the mask.
- If the bottom headgear straps are too tight, the top part of the mask can pull forward causing leaks into the eyes which is poorly tolerate by the patient. This excessive pressure to the upper lip (in the case of a nasal mask) or lower lip/chin area (in the case of an oro-nasal mask) can potentially result in irritation or skin breakdown.
- When applying the mask, take care to apply the correct tension to the headgear straps.
- If the upper straps are too tight, leaks will occur around mouth and will increase the potential of too much pressure on the bridge.
- A properly fitted mask can be achieved by first sizing the mask using the sizing gauge to obtain the correct mask size. Remember to size oro-nasal masks with the mouth slightly ajar.
- Reposition mask if necessary by gently pulling the cushion away from the nose and then back to the initial fit. The mask should 'float' on the patient's face and should be properly balanced. The use of a correctly sized and position forehead cushion will offset pressure on the bridge of the nose and will help achieve mask balance.